Ivoclar Systemp.Onlay & Systemp.Inlay Universal Refills

Systemp.inlay and Systemp.onlay are light-curing single-component materials for the fabrication of temporary restorations and do not require the additional use of a temporary cementation material.

Systemp.inlay is particularly recommended for deep inlay preparations with parallel walls as well as for sealing implant screw access canals and for relining prefabricated crowns and bridges. Systemp.inlay is available in two shades, universal and transparent, and in two delivery forms (syringe and Cavifil).

Systemp.onlay achieves a more rigid final cure than System.inlay because it features a higher content of inorganic fillers. The higher strength of Systemp.onlay provides advantages with regard to retention and occlusal and sagittal bracing. Therefore, the material is suited for large preparations.

In addition, Systemp.onlay is suitable for long-term temporaries, flat preparations and preparations with strongly diverging walls. Systemp.onlay is available in two shades, universal and transparent, and in two delivery forms (syringe and Cavifil).

COMPOSITION:

Systemp.inlay

The monomer matrix consists of high-molecular dimethacrylates. The fillers are highly dispersed silicon dioxide and copolymers. Triclosan, catalysts and stabilizers are additional ingredients.

Systemp.onlay

The monomer matrix consists of high-molecular dimethacrylates. The fillers are highly dispersed silicon dioxide and copolymers. Triclosan, catalysts and stabilizers are additional ingredients.

INDICATION:

• Systemp.inlay is especially suitable for deep inlay preparations with parallel walls. Systemp.inlay can also be used if small undercuts are present.
• Systemp.inlay is also suitable for relining prefabricated, temporary crowns and bridges made of polycarbonate or methacrylates.
• Systemp.inlay is also suitable for sealing implant screw access openings. –
• Systemp.onlay is especially suitable for large preparations (onlays). If undercuts are present, please note that after curing, Systemp onlay is less elastic than Systemp.inlay, which may complicate removal

• 3 x 2.5g Refills

Preparation appointment

Step 1: Prepare, place base or liner and take impression as usual.

Step 2: Dry prepared teeth; use a matrix if necessary.

Step 3: Clean cavity with water spray

Step 4: Application of Systemp.desensitizer: Apply Systemp.desensitizer and brush the material gently into the dentin for 10 seconds

Step 5: Carefully dry with blown air

Step 6: Place a sufficient quantity of Systemp.inlay or Systemp.onlay into the cavity, using a spatula or another suitable instrument. If you use Cavifils, the material can be applied directly into the cavity by means of the Cavifil Injector. Contour the restoration, leaving minimum excess.

Step 7: Increments of up to 4 mm can be cured with a standard curing light (e.g. bluephase® C5) in 10 seconds, if the light intensity is higher than 500 mW/cm2. The same depth of cure is achieved with LED lights that produce a higher light intensity (e.g. bluephase®) after an exposure time of 10 seconds in the low power mode (LOP).

Step 8: Remove matrix

Step 9: Check occlusion.

Insertion appointment

Step 1: Insert a suitable instrument (e.g. probe/scaler) into the temporary restoration. Remove Systemp.inlay or Systemp.onlay from the cavity

Step 2: Subsequently, clean the cavity (e.g. with rubber cups and cleaning paste).

Step 3: Try in and seat the restoration.

1. Prepare, place base or liner and take impression as usual. -  Anil

2. Prepare, place base or liner and take impression as usual. -  Om Ganga Sagar